Panasonic AW-RL400G, AW-RP400E, AW-RC400E manual $ Front panel

Pan/Tilt Head Controller AW-RP400

Parts and their function

$ Front panel	; < = > ? @ A B C D	E F G H I	1	ENGLISH
2
3
4				J
5
6				K
7
8
9
:				L

1EXT CONT [M/S] switch NOTE

This switch is normally kept at the [M] (master) position. When an additional AW-RP400 controller has been installed, set the EXT CONT switch on the additional unit to [S] (slave).

If no additional AW-RP400 controller is going to be installed, the EXT CONT switch on this controller must be kept at the [M] (master) position without fail.

When an additional AW-RP400 controller is installed and used, it will not be possible to exercise control from the slave controller unless the OPERATE switches not only on the slave controller but on the master controller as well are set to [ON]. Remember to set the OPERATE switch on the slave controller to [ON] first before setting the OPERATE switch on the master controller to [ON].

2OPERATE lamp

This lights up green when the (3) OPERATE switch is at ON. It goes off when the switch is set to OFF.

3OPERATE [OFF/ON] switch

When this switch is set to [ON], the power supply from the connected pan/tilt heads to the cameras is turned on, and system control is enabled.

When it is set to [OFF], the power supply from the connected pan/tilt heads to the cameras is turned off.

4INCOM jack

The INCOM (inter-communication) headset is connected here.

5LEVEL control

Use this to adjust the volume of the headset’s receiver.

6CALL button

When this button is pressed, the buzzer of the connected controller sounds, and the CALL button lamp lights.

20 (E)