Panasonic AW-RL400G, AW-RP400E $ Rear panel, Mext Cont IN/OUT connectors OTALLY/INCOM connector

Pan/Tilt Head Controller AW-RP400

Parts and their function

$ Rear panel M N O P Q

R	S	T	U
MEXT CONT IN/OUT connectors		OTALLY/INCOM connector

When an additional AW-RP400 controller is to be provided, connect these connectors on the two AW-RP400 controllers using a 10BASE-T (equivalent to UTP category 5) straight cable.

Master				Slave
controller			controller
AW-RP400			AW-RP400
EXT CONT			EXT CONT
	IN				IN
		10BASE-T
EXT CONT			EXT CONT
		10BASE-T straight cable
	OUT				OUT

NCAMERA CONTROL IN FROM RCB [P1] to [P5] connectors

Connect the WV-CB700A remote control boxes to these connectors.

The cameras installed on the pan/tilt heads corresponding to the ports where the WV-CB700A boxes have been connected can then be controlled.

When even one WV-CB700A box is connected, the cameras cannot be controlled from the AW-CB400 remote operation panel even if the AW-CB400 is connected.

Connect this to the TALLY/INCOM connector on the video switcher or other unit.

When the TALLY input connector is set to the GND level, the TALLY lamp on the controller or pan/tilt head lights. Do not apply a voltage in excess of 5V to this connector.

87654321

?>=<;:9

Pin layout as seen from the back panel of AW-RP400

Pin No.		Signal name
1		TALLY1
	9	TALLY2
2		TALLY3
	10	TALLY4
3		TALLY5
	11	TALLY GND
4		– – –
	12	– – –
5		– – –
	13	– – –
6		MIC+
	14	MIC–
7		INCOM GND
	15	SP–
8		SP+

Use the accessory plug (D-SUB 15-pin) to connect the tally/INCOM signals to the system.

Connect a 4-wire INCOM system to the INCOM connector.

When an additional controller has been provided or when the AW-CB400 remote operation panel has been connected, the tally or INCOM function of all the units will take effect if tally or INCOM signals are connected to one of the units.

23 (E)