Using an External Display
28
1 Power off your computer (
"Starting Up/Shutting Down") Do not shut down using the suspend or hibernation mode.
CAUTION
Do not install or remove peripherals while your computer is in the suspend or hibernation mode; abnormal operation may result.
2 Connect the external display to your computer
External Display Port
NOTE
For more detailed information, please refer to the operation manual of the external display.
3 Turn on the external display, then turn on your computer with the display opened
You can select either an external display, LCD or simultaneous with Fn
+F3 .
In addition, you can set the display to use during
1
2
Run the Setup Utility (
page 34)
Using 
and 
, select [System Setup], then press Enter
3
4
Using 
and 
, select [Display], select the display to
use with 
, then press Esc
Close the Setup Utility (
page 34)
4 Select your external display
Set your external display for [Monitor] in [Start] - [Settings] - [Control Panel] - [Display] - [Settings] - [Advanced Properties].
When a monitor that does not conform to the Plug & Play standards is connected, select [Change] and make the monitor settings.
