Suspend/Hibernation Functions
1 3
Starting Up Your Computer Quickly
If you want to immediately start up and continue an application after shutting down your computer, you can do so by using the suspend or hibernation function.
Differences between the suspend and hibernation functions
F u n c t i o n
Where data is saved to
S p e e d
R e q u i r e s p o w e r s u p p l y
Suspend function
M e m o r y
Fast
Yes (if power is cut, all data is lost)
Hibernation function
Hard disk
Somewhat slow
Power not required to maintain data
Setting the Suspend or Hibernation Function
[Hibernation] is factory set. |
|
| ||
1 | Run the Setup Utility ( | page 37) | ||
2 Using | and | , select [Power] | ||
3 | Using | and | , select [Power Switch] and press Enter | |
4 | Using | and | , select [Suspend] or [Hibernation] and | |
| press | Enter |
|
|
5 | Press | F10 , then select [Yes] | ||
N O T E
The Suspend or Hibernation function can be set even with [Panel Switch] in the
Setup Utility. 
page 41
Shutting Down Using the Suspend or Hibernation Function
The computer should be set for suspend or hibernation (
see the above proce- dure).
Slide the power switch
(After releasing your finger from the power switch, do not touch the power switch, keyboard or mouse while the computer is entering in the suspend or hibernation modes.)
Suspend Mode
or
Hibernation Mode
CAUTION
At the "beep*" sound, release your finger from the power switch. If you con- tinue to slide the switch and hold it for more than four seconds, the power will go off. Data not previously saved will be lost.
Slide the power switch to power on.
If the computer will not be operated for an extended period of time, it is recom- mended that hibernation mode be used instead of the suspend mode.
*When the speaker function is disabled, e.g., by setting [Disable] for [Speaker] with the
Setup Utility ( | page 38) or by the key combination Fn + F4 , there will be no beep |
sound. |
|
(To next page)
