Panasonic CF-P1Series operating instructions Application Software, Display, Connecting a Host PC

Application Software

The computer locks up dur- ing the execution of an ap- plication, or the execution speed becomes noticeably slower.

Connect the AC adaptor and push the reset switch. Check the remaining battery level and make sure that multiple applications are not running simultaneously. Close all applications that are not being used.

Display

It is hard to view the LCD.	The LCD backlight may have automatically turned off
	due to the power-saving function. Turn on the LCD back-
	light by holding down the power switch until the back-
	light goes on.
	Adjust the backlight brightness.
	1 Tap	- [Settings] - [System] tab - [Backlight].

2Tap the [Brightness] tab and adjust the brightness with the slider.

The cursor cannot be con- Push the reset switch to restart. trolled.

The cursor does not prop-	Align the screen ( page 21).
erly correspond to a stylus
tap.

Even when the CF-P1’s power is switched off, only the power to the LCD turns off, but the power to the main unit remains on (in- put from the keyboard is still possible).

Enable the Microsoft® ActiveSync® connection, and syn- chronize CF-P1 with the host computer. If this situation

occurs frequently, tap - [ActiveSync] - [Tools] - [Options] - [PC] tab to remove the checkmark from [Use mobile schedule to sync with this PC] and reset.

Connecting a Host PC

A host computer does not recognize CF-P1.

Confirm that Microsoft® ActiveSync® 3.7 (or a later ver- sion) has been installed in the host computer.

Check to see if a fully charged battery pack is properly installed to CF-P1.

If a modem card has been inserted, disconnect these de- vices and check the communication status again.

Confirm that CF-P1’s power is on.

Push the reset switch to restart.

If a cable or cradle is being used for the connection, recheck the connection to the host computer.

45