180
Troubleshooting (Advanced)

Removing data from the reader

When enrollment to the device is used, passport data is stored to the device . To remove it, go to the [Delete user data]
passport wizard and delete existing passports.

“Lift Finger” is displayed during operation

You can temporarily disable the fingerprint sensor with the following procedure.
A Click on the notification area and then right-click the “Fingerprint software” icon .
BSelect [Don’t Use Sensor].
The icon turns gray.
To enable the fingerprint sensor, proceed as follows.
ARight-click the “Fingerprint software” icon .
BSelect [Use Sensor].

Unable to connect to a network

Check that the network you are using ([Modem], [LAN], [Wireless LAN], [Wireless WAN] or [Bluetooth]) is set to [Enabled]
in the [Advanced] menu of the Setup Utility ( page 151 ).
Restart the computer.
When using the computer as a network computer, some additional settings may have to be made depending on the usage
conditions. We recommend asking your system administrator or the person in charge of the network.
If the hub unit link lump does not light up, one of the following problems m ay have occurred.
• A problem or failure in the hub unit
• Incorr ect cable type or incorrect connection
• A break in the cable
Right-click the Wireless Switch Utility icon ( page 134). If [Wireless LAN OFF] has been checked, click [Wireless LAN
ON]. If only one wireless function is equipped, this menu is not displayed. The power is turned on with the wireless switch
only.

Cannot check the computer’s MAC address

Check the computer’s MAC address using the following procedure:
ACheck that the LAN or wireless LAN is not disabled in the Setup Utility or the Device Manager.
Problems with General Network
Windows 7