1.The inside and outside connecting cable can be connected without removing the front grille.
2.Connecting cable between indoor unit and outdoor unit shall be approved polychloroprene sheathed 4 × 1.5 mm2 flexible cord, type designation 245 IEC 57
••Ensure the color of wires of outdoor unit and the terminal Nos. are the same to the indoor’s respectively.
••Earth lead wire shall be longer than the other lead wires as shown in the figure for the electrical safety in case of the slipping out of the cord from the anchorage.
••Secure the cable onto the control board with the holder (clamper).
AUTO SWITCH OPERATION
The below operations will be performed by pressing the “AUTO” switch.
••AUTO OPERATION MODE
The Auto operation will be activated immediately once the Auto Switch is pressed.
••TEST RUN OPERATION (for PUMP DOWN/SERVICING PURPOSE)
The Test Run operation will be activated if the Auto Switch is pressed continuously for more than 5 sec. to below 8 sec. A “pep” sound will occur at the fifth sec., in order to identify the starting of Test Run operation.
HOW TO TAKE OUT CORNER PIECE (LEFT UNDER)
HOW TO TAKE OUT FRONT GRILLE
Please follow the steps below to take out front grille if necessary such as when servicing.
1.Set the vertical airflow direction louver to the horizontal position.
2.Slide down the two caps on the front grille as shown in the illustration at the right, and then remove the three mounting screws.
3.Pull the lower section of the front grille towards you to remove the front grille.
Caution
When reinstalling the front grille, first set the vertical airflow direction louver to the horizontal position and then carry out above steps 2 - 3 in the reverse order.
Please check that the top side of front grille certainly caught with fixative rib (4 points) of indoor unit.
51