5.Place the Control Box reversely and remove the screws (two) on the both sides of the Control Box B (for Terminal Plate).

CS-HE9DKE CU-HE9DKE / CS-HE12DKE CU-HE12DKE

13.3.2.5.Removal of Propeller Fan and Fan Motor

1.Remove the Cabinet Top Plate and Cabinet Front Plate according to 13.3.2.1.

2.Remove the Control Box by releasing the hooks (four: two each on the both sides).

Fig. 10

6.Release the hooks (four) on the Control Box A (Lower Control PCB Cover).

Note: Be careful of hanging-up of connectors or wiring cables such as the earth wire when the Box A is removed.

Fig. 11

7.For the Control Board, replacement is made together with the Control Box.

Fig. 13

3.Remove only the Connector for the CN-FM1 (Outdoor unit Fan Motor).

4.Remove the Propeller Fan by turning the nut in the center of the fan clockwise.

Fig. 14

5. Remove the Fan Motor by loosening the screw (four).

Fig. 15

Note: Adjust the location of the Boss in the center of the Propeller and the matching groove on the shaft of the Motor when putting them together.

Fig. 12

•• Replacement of the Outdoor Control PCB should be made as a whole unit due to silicon pasting, etc. although it can be separated PCB part from Control BOX plastic part by removing the screws (six) on the PCB.

Fig. 16

79