13.3. Disassembly of Parts
13.3.1.Disassembly of Indoor Unit
13.3.1.1.Removal of the Front Grille
1.Pull the Front Panel up slowly.
Note: Open it by holding up the
Fig. 1
Fig. 2
6.Remove the Top Panel by pressing up the triangle marks (3 points) on it.
Fig. 5
7.Remove the Front Grille by pulling it up with taking notice of the Chassis Complete and the hooks (four).
Fig. 6
2.Remove it inside by pressing Lever Arm with finger.
3.Remove the screw (one) in center part of the unit.
Fig. 3
4.Make the Vertical Louver level (horizontal).
5.Pull up the Screw Caps (2 parts) and remove the screws (two) inside.
Fig. 4
13.3.1.2. Removal of Control Board Box
1.Remove the Front Grille according to the procedure 13.3.1.1.
2.Remove the screws (two) for the interconnect cable holder and the cable.
3.Remove the screws (two) fixing the Terminal Plate. (The Terminal Plate will be in the air.)
Fig. 7
Fig. 8
72