Setup

≥The recordable times will vary depending on the status of use. These times are approximations.

The recordable time will become shorter in the following cases:

When you use both the viewfinder and the LCD monitor simultaneously while rotating the LCD monitor frontward to record yourself, using the 0 Lux MagicPix function, etc.

When you use this unit with the LCD monitor lit up by pressing the POWER LCD button.

≥The batteries heat up after use or charging. This unit will also heat up while being used. This is not a malfunction.

≥Be aware that the operating time of the battery will become shorter in low temperatures. We recommend charging a spare battery for use when recording.

ªAbout the remaining battery

capacity indication

The remaining battery capacity is displayed in minutes when using the Panasonic battery that you can use for this unit. It may take time to display the remaining battery capacity.

90min

≥The display changes as the battery capacity reduces.

# # # # . If there is less than 3 minutes remaining, then will become red. If the battery

discharges, then will flash.

≥The remaining battery capacity may not be displayed correctly where the temperature is low or high or if the battery was not used for a long period of time.

To correctly display the remaining battery capacity, recharge the battery, discharge it and then charge it again. (Even if this operation is performed, it may not be possible to display the remaining battery capacity correctly if the battery was used for a long period of time where the temperature is low or high or if the battery was repeatedly charged.)

≥The maximum amount of remaining battery capacity able to be indicated is 240 minutes. If the actual remaining time exceeds

240 minutes, the indication will stay green and will not change until the remaining time falls below 240 minutes.

≥Depending on the conditions of use, the time displayed on the remaining battery capacity indication will change so use it as an approximation.

≥When turning the mode dial to switch modes, the time indication will turn off in order to recalculate the remaining battery capacity time.

≥When using batteries made by other companies the remaining battery capacity will not be shown.

Connecting to the AC outlet

1Connect the AC cable to the AC adaptor and the AC outlet.

2Connect the DC cable to the AC adaptor.

3Connect the DC cable to the DC

input terminal DC IN 7.3V.

≥Do not use the AC cable with any other equipment as it is designed only for this unit. Do not use the AC cable from other equipment with this unit.

≥While the DC cable is connected to the AC adaptor, the battery will not charge.

33

LSQT1093

Page 33
Image 33
Panasonic HDC-DX1PC operating instructions Connecting to the AC outlet, About the remaining battery Capacity indication