Panasonic HDC-DX1P, HDC-DX1PC 1 2, 3, Setting date and time, 1, 2, 3

45
LSQT1093
Setup
To exit the menu screen
Press the MENU button.
≥The menu screen does not appear during
recording or playing. You cannot start other
operations while the menu screen appears.
The menu screen transition is the same as when
the buttons on the main unit are used.
1Press the MENU button.
2Select a menu item.
≥Use the direction buttons (3, 4, 2, 1)
and ENTER button in place of the cursor
button on the main unit.
3Press the MENU button to exit
the menu screen.
Setting date and time
When the unit is turned on for the first time, a
message asking you to set the date and time will
appear. Move the cursor button up or down to
select [YES], press the center of the cursor
button and then perform steps 2 and 3 below to
set the date and time.
¬Rotate the mode dial to select .
1Press the MENU button, then
select [BASIC] # [CLOCK SET] #
[YES] and press the cursor
button.
2Move the cursor button left or
right to select the item to be set.
Then, move the cursor button up
or down to set the desired value.
≥The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥The 12-hour system is used to display the
time.
3Press the cursor button to enter
the selection.
≥The clock function starts at [00] seconds
when the cursor button is pressed.
≥After pressing the MENU button to finish
the setting, check the date and time
display.
Operating with remote control
MENU
MENU
ENTER
MENU
ENTER
MENU
ENTER
LSQT1093ENG.book 45 ページ ２００７年１月１５日 月曜日 午前９時２３分