Panasonic HDC-DX1PC Screen indications in the disc recording mode, Recording time elapsed

Recording

ªScreen indications in the disc recording mode

A

B

C

ARecording mode

BRemaining time left for recording

(When the remaining time is less than 1 minute, [R0min] flashes red.)

CRecording time elapsed

≥The maximum number of scenes on a disc (per side): 999 (Even if there is remaining capacity for recording on a disc, you may not be able to record 999 scenes.)

≥The maximum number of recordable scenes with different dates (on one side of the disc): 99 (In some cases, scenes recorded on the same day will be recorded with different dates

(l 77))

≥Discs with more than the maximum scenes or dates cannot be used with this unit.

≥Sound is recorded from the internal microphones on the top of this unit. Take care not to block this microphone.

≥Put the unit in pause mode when connecting or disconnecting an external microphone with the MIC terminal. If an external microphone is connected or disconnected while recording, the audio will not be recorded properly.

≥Each time the unit is put into recording pause, the counter display will be reset to “0h00m00s”.

≥While motion picture recording is in progress, the recording will not stop even if the LCD monitor is closed and the viewfinder is retracted.

≥While “WRITING CONTROL DATA TO THE DISC. DO NOT SHAKE THE UNIT.” is displayed, do not disconnect the AC adaptor or remove the battery as doing so may make the disc unusable.

≥While motion picture recording is in progress, do not disconnect the AC adaptor or remove the battery. If you do, a repair disc message may be displayed when the power is turned back on. (l 115)

The ACCESS/PC lamp lights immediately after recording finishes. While it lights, the disc is rotating and disc information is being recorded. If you run while holding the unit or swing it, the recorded images may be distorted so do not strongly shake or cause impact to it.

51

LSQT1093