12
VQT1Y31
Quick Guide∫Charging the battery
1Connect the AC cable to the AC adaptor and
the AC outlet.
2Insert the battery into the AC adaptor by
aligning the arrows.
∫Inserting the battery
Install the battery by inserting it in the direction
shown in the figure.
AInsert the battery until it clicks and locks.
∫Inserting/removing an SD card
1) Open the LCD monitor.
≥Check that the access lamp has gone off.
2) Open the SD card cover by sliding the OPEN
lever B.
3) Insert/remove the SD card.
≥Face the label side C in the direction shown in
the illustration and press it straight in as far as
it will go.
≥Press the center of the SD card and then pull it
straight out.
4) Securely close the SD card cover.
≥Securely close it until it clicks.
Charging lamp
[CHARGE] A
Lights up:
Charging
Goes off:
Charging
completed
Access lamp [ACCESS] A
≥When this unit is accessing the SD card, the
access lamp lights up.
HDCHS250P-VQT1Y31_eng.book 12 ページ 2009年1月20日 火曜日 午前11時18分