Panasonic HDC-SX5PC operating instructions Troubleshooting, Unit operations, 140

Others

Troubleshooting

ª Unit operations

Problem	Check points
	≥ Is the battery fully charged?
This unit cannot be	# Charge the battery using the AC adaptor. (l 31)
	≥ The battery protection circuit may have operated. Attach the battery
turned on.	to the AC adaptor for 5 to 10 seconds. If the unit still cannot be
	used, the battery is faulty.
	≥ Make sure the LCD monitor is opened or the viewfinder extended.
	≥ If you do not use the unit for approximately 5 minutes, the power is
	automatically turned off to conserve battery life. To resume
	recording, turn the power back on. The power will not turn off
This unit is turned off	automatically when the power save function is set to [OFF]. (l 131)
	≥ Are you connecting to a TV compatible with EZ Sync with a HDMI
automatically.	cable?
	# If you connect to a TV compatible with EZ Sync with a HDMI
	cable and turn off the power on the TV with the remote control for
	the TV, the power on this unit also turns off. If you are not using
	EZ Sync, set [EZ Sync] to [OFF]. (l 103)
This unit does not stay	≥ Is the battery low?
	# If the remaining battery power indication is flashing or the
on long enough.	message “CHANGE THE BATTERY.” is displayed, the battery
	has run down. Charge the battery. (l 31)
	≥ Is the battery fully charged?
	# Charge it with the AC adaptor. (l 31)
	≥ Are you using the battery in an extremely cold place?
Battery runs down	# The battery is affected by ambient temperature. In cold places,
	battery life becomes shorter.
quickly.
	≥ Has the battery worn out?
	# The battery has a limited life. If the operating time is still too short
	even after the battery is fully charged, the battery has worn out
	and needs to be replaced.
	≥ The remaining battery capacity indication is an approximation. If
The minute display of the	you think the remaining battery capacity indication is not displayed
	correctly, fully charge the battery, discharge it and then charge it
remaining battery power
	again. (Even if this operation is performed, it may not be possible to
indication is not
	display the remaining battery capacity correctly if the battery was
displayed correctly.
	used for a long period of time where the temperature was low or
	high or if the battery was repeatedly charged.)

140

VQT1J42