Panasonic HDC-SX5PC operating instructions To cancel Quick start

Setup

Quick start

When quick start is ON the battery power is still being consumed, even when the LCD monitor and the viewfinder are closed.

This unit will resume recording/pause mode about 1.7 seconds after the LCD monitor or the viewfinder are reopened.

≥When in quick start standby mode, about 70% of the power used in recording pause mode is being consumed so the recording time will be reduced.

≥This is only activated in the following case.

sWhen the mode dial is set to and an

SD card is inserted.

1Press the MENU button, then select [SETUP] # [QUICK START]

# [ON] and press the cursor button.

MENU

2Close the LCD monitor and retract the viewfinder while the mode dial is set to .

The status indicator A flashes green and the unit goes into quick start standby mode.

≥The lens cover does not close.

3Open the LCD monitor or extend the viewfinder.

The status indicator A lights red and the unit is put into recording pause approx. 1.7 seconds after it is turned on.

ªTo cancel Quick start

Press the MENU button, then select [SETUP]

#[QUICK START] # [OFF] and press the cursor button.

≥ The status indicator goes off, the lens cover closes and the power turns off if the mode dial is set to OFF while the unit is in quick start standby mode.

≥ The status indicator goes off and the power turns off if quick start standby mode continues for approx. 5 minutes.

≥Quick start standby mode is canceled, if jthe mode dial is switched

jthe battery is removed or the AC adaptor is disconnected

≥In the quick start mode, it may take some time for automatic white balance to adjust, if the scene being recorded has a light source different from the scene last recorded. (When the MagicPix function is used, however, the white balance of the scene last recorded is retained.)

≥In the quick start mode, the zoom magnification becomes 1k and the picture size may differ from what it was before quick start standby mode.

≥If [POWER SAVE] (l 131) is set to

[5 MINUTES] and the unit automatically goes into quick start standby mode, close the LCD monitor and then open it again.

38

VQT1J42