Panasonic HDC-SX5PC operating instructions About recovery, 137

	Others
CANNOT SET.	The [GUIDE LINES], [ZEBRA], [MF ASSIST], [MIC LEVEL] and
	[RED EYE] menu settings cannot be set when the color bar is set.
DISCONNECT USB	The unit cannot correctly establish the connection to the computer
CABLE.	or printer. Disconnect and then reconnect the USB cable.
(HD mode) DISCONNECT
USB CABLE.
(STD mode) CANNOT	The unit’s power cannot be turned off when the unit is connected to
	the computer.
OPERATE WHILE
CONNECTED TO
COMPUTER.

About recovery

It is possible that the system cannot complete writing of a file normally when, for example, power is turned off for some reason during recording or editing.

If faulty management information is found when a disc or an SD card is accessed, the following message may appear. (Repairing may take time depending on the error.)

¬HD mode

CONTROL DATA ERROR HAS BEEN

DETECTED.

When connecting to AC adaptor or the remaining capacity of the battery is enough: [FINISHED.]

When the remaining capacity of the battery is low:

[CANNOT REPAIR CONTROL INFORMATION DUE TO LOW BATTERY POWER.]

THUMBNAIL DATA ERROR IS DETECTED.

When connecting to AC adaptor or the remaining capacity of the battery is enough:

[THUMBNAIL DATA HAS BEEN REPAIRED SUCCESSFULLY.]

When the remaining capacity of the battery is low:

[CANNOT REPAIR CONTROL INFORMATION DUE TO LOW BATTERY POWER.]

¬STD mode

DISC ERROR HAS OCCURRED. NOW

REPAIRING DATA ON THE DISC.

≥Use a sufficiently charged battery or the AC adaptor.

≥Depending on the condition of the data, it may not be possible to completely repair the data.

≥If the recovery fails, you will no longer be able to playback the data recorded before the power went off.

≥When data recorded on another device is recovered, it may not be possible to play back the data on this unit or the other device.

≥If the thumbnail information is recovered, displaying the thumbnails may become slower.

137

VQT1J42