Panasonic KX-HCM250 operating instructions Network window on, Transfers older

	Operating Instructions
	About Network Camera Setup
Problem	Cause and Remedy
Green indicator	Internal Failure of the server or the congestion on the network
continues	traffic when using DHCP may prevent Network Camera from
blinking.	getting the IP address. Ask the network administrator or your ISP.
Orange	Orange indicator blinks when updating firmware on page 91. When
indicator	the Update Firmware failed, refer to page 120.
continues
blinking.
Red indicator	If you cannot access Network Camera, the Network Camera
continues	hardware may be defective. Call our customer call center.
blinking.
Image Transfer	• Default Gateway and DNS server address should be set up on
on e-mail or FTP	Network window on page 58.
does not work.	• If FTP does not work properly, ask your ISP or network
	administrator about the transferring mode of FTP server.
	[Passive Mode] or [Active Mode] is available.
	• Select [One Time] for Login Timing when transferring images
	by FTP in short duration time.
Timer mode	Short interval of Image Buffer Frequency makes Network Camera
transfers older	transfer the older images. Set the interval long enough to transfer
images.	the images. Buffered Image screen enables you to check this
	setting.
Wireless	• Signal strength is weak. Change the location of Network
communication	Camera or get rid of the obstacle around Network Camera.
does not work.	• SSID and Encryption setting of Network Camera are different
	from those of the wireless router or the wireless LAN card of
	PC. SSID and Encryption setting must be identical between
	Network Camera and wireless router.
	• Draw out the Ethernet cable and reconnect the AC adaptor for
	Network Camera to recognize the Wireless Communication
	mode.
Wired	Reconnect AC adaptor for Network Camera to recognize the
communication	change from wireless to wired communication or vice versa.
does not work.

[For assistance, please call: 1-800-272-7033] 119