Panasonic KX-HGW600 Features, System, Instructions for the data fields, Entry, IP Address WAN

		Operating Instructions
	Instructions for the data fields
Entry	Check Enabled or Disabled. When you check Enabled, the
	entry works as specified. When you check Disabled, the
	entry does not work but will work when you check Enabled
	later.
IP Address (WAN)	Enter the global IP address to send or receive data to/from
	the WAN side.
Protocol	Select the protocol(s) to send or receive data to/from the
	WAN side. TCP, UDP, TCP&UDP, ICMP, PPTP or		are
	available.
Forwarding Port No.	Set the port number(s) to send or receive data to/from the
	WAN side. Do not enter the space.
	• When a single port is desired, set the port number.
	• When a range of port is desired, enter the range using "-".
	For example, to set the port numbers from 2000 to 3000,
	enter as "2000-3000". The starting port number must be
	lower in value than ending port number.
	The port numbers from 60000 to 60016 are only available
	for the KX-HGW600.
	• When you select	in the Protocol, be sure to enter "		" in
	this data field.
IP Address (LAN)	Enter the private IP address of each device connected to the
	KX-HGW600. A data from the WAN side is forwarded to the
	IP address entered in this data field. In this case, set the IP
	address of the corresponding Network Camera to this value.
IP Masquerade	When multiple global IP addresses are assigned by the ISP,
	enter one of them as the IP address for IP Masquerade
	function. When it is set to blank, the IP address assigned on
	the Basic Setup window or the IP address assigned by the
	ISP is used.

Features System

[For assistance, please call: 1-800-272-7033] 99