Panasonic KX-HGW600 manual connected to the other wireless routers. In this case

Operating Instructions

About Network Camera Setup

Problem		Cause and Remedy
The Automatic Setup function	•	Make sure the connection between the device and
does not work.		the KX-HGW600 have been successfully made.
	•	The Automatic Setup function is only available for
		20 minutes after the Network Camera is turned on.
		Restart the Network Camera.
	• Make sure Enable is checked on the Network
		window of Network Camera ([Network]		1.
		Network Configuration from the Setup
		Program).
	•	If you connect the KX-HGW600 to the wireless
		devices, make sure the wireless devices are not
		connected to the other wireless routers. In this case,
		turn off the other routers and restart the Network
		Camera. Then, set the same SSID to the
		KX-HGW600 and the Network Camera.
	•	The IP addresses "192.168.0.113 - 192.168.0.128"
		are used for the Automatic Setup function. If the
		other devices use the corresponding IP addresses,
		change the other IP addresses.
The authentication window	•	Administrator Only is checked on the Access
appears when you access the		Control window. Enter the registered user name and
Camera Portal page.		password.
	•	If the authentication of the Network Camera is set
		Administrator and General User on the Security:
		Administrator window, please change the setting to
		Administrator Only.
The automatically set up	•	If you check Do Not Use on the Setup Page of the
Network Camera is removed		KX-HGW600 ([Optional Setup]	DHCP), set up
from the Camera Portal page.		the Network Camera manually.
You cannot set up the	•	The IP addresses "192.168.0.113 - 192.168.0.128"
Network Camera manually.		and the port numbers "60001 - 60016" are used for
		the Automatic Setup function. If you use the
		corresponding IP addresses or port numbers,
		change to the other IP addresses or port numbers.

142