Cancelling a base unit
A handset can be registered to a maximum of 4 base units. A handset can cancel a base unit that it is registered to. This allows the handset to “forget” the base unit.
1Press {j/OK}.
2Select “Handset Setup”, then press {>}.
3Select “Registration”, then press {>}.
4Enter “335”.
5Select “Cancel Base”, then press {>}.
6Enter “0000” (default handset PIN).
LIf you changed the PIN, enter it (page 28).
7Select the base unit(s) you want to cancel, by pressing the desired base unit number.
LThe selected base unit number(s) will flash.
LTo cancel a selected base unit number, press the number again. The number will stop flashing.
8Press {j/OK}.
9Select “Yes”, then press {>}.
10Press {ih}.
Note:
LTo register the handset to another base unit or to the same base unit again, see manual registration (page 47).
Increasing the range of the base unit
You can increase the range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 5. Consult your Panasonic dealer for details.
Important:
LBefore registering the repeater to this base unit, you must turn the repeater mode on.
Turning the repeater mode on/off
1Press {j/OK}.
2Select “Base Unit Setup”, then press {>}.
3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page
34).
4Select “Other Options”, then press {>}.
5Select “Repeater Mode”, then press {>}.
6Select “On” or “Off”, then press {>}.
7Press {ih}.
Note:
LAfter turning repeater mode on or off,
certain icons displayed on the base unit will disappear for a moment and w will
flash on the handset momentarily. This is normal. The handset can be used once w stops flashing.
LWhile the repeater mode is turned on, audible call announcements may not be heard from the handset speaker.
Intercom
Intercom calls can be made between handsets/base unit in the same radio cell.
Between a handset and the base unit
When a handset calls the base unit
1Handset:
Press {INT} and {0}.
48
