Panasonic KX-TG1840NZ operating instructions Ringer setup, Night mode

Base Unit Settings

Ringer setup

Night mode

Night mode allows you to select a block of time during which the base unit will not ring for outside calls. This feature is useful for times when you do not want to be disturbed, for example, while sleeping. Night mode can be set independently for the handset (page 26) and the base unit.

Set the date and time beforehand (page 11).

Note:

LTo avoid disturbances, we recommend turning the call screening feature off (page 44) in addition to turning the night mode feature on.

Setting the start and end time for night mode

1Press {j/OK}.

2Select “Base Unit Setup”, then press {>}.

3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page

34).

4Select “Ringer Setup”, then press {>}.

5Select “Night Mode”, then press {>}.

6Select “Start/End”, then press {>}.

7Enter the desired hour and minute you wish to start this feature by selecting 2 digits for each.

LIf you use 12-hour time entry, select “AM” or “PM” by pressing {*} repeatedly before entering the time.

8Enter the desired hour and minute you wish to end this feature by selecting 2 digits for each.

LIf you use 12-hour time entry, select “AM” or “PM” by pressing {*} repeatedly before entering the time.

9Press {j/OK}.

10Press {ih}.

Turning night mode on/off

1Press {j/OK}.

2Select “Base Unit Setup”, then press {>}.

3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page

34).

4Select “Ringer Setup”, then press {>}.

5Select “Night Mode”, then press {>}.

6Select “On/Off”, then press {>}.

7Select “On” or “Off”, then press {>}.

8Press {ih}.

Setting the ring delay for night mode

This setting allows the base unit to ring during night mode if the caller waits long enough. After the selected amount of time passes, the base unit will ring. If you select “No Ringing”, the base unit will not ring during night mode.

1Press {j/OK}.

2Select “Base Unit Setup”, then press {>}.

3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page

34).

4Select “Ringer Setup”, then press {>}.

5Select “Night Mode”, then press {>}.

6Select “Ring Delay”, then press {>}.

7Select the desired setting, then press {>}.

8Press {ih}.

Note:

LWhen the answering system answers the call, this feature does not work.

31