Programming

Changing the base unit PIN (Personal Identification Number)

Important:

RIf you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to you. If you forget your PIN, contact an authorised service centre.

1 (middle soft key) #132

2Enter the current 4-digit base unit PIN (default: 0000).

3Enter the new 4-digit base unit PIN. a

a M N

Registering a unit

Operating additional units

Additional handsets

Up to 6 handsets can be registered to the base unit.

Important:

RThe additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations (handset settings, base unit settings, etc.) may not be available.

Registering a handset to the base unit

The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, is displayed even when the handset is near the base unit), re-register the handset.

1Handset:

(middle soft key) #130

2Base unit:

Press and hold MN for about 5 seconds, until the registration tone sounds.

RIf all registered handsets start ringing, press MN again to stop, then repeat this step.

RThe next step must be completed within 90 seconds.

3Handset:

a Wait until Base PINis displayed. a Enter the base unit PIN

(default: 0000). a

R If you forget your PIN, contact an authorised service centre.

R When the handset has been registered

successfully, is displayed.

Note:

R While registering, Base in registeringis displayed on all registered handsets.

RWhen you purchase an additional handset, refer to the additional handset’s installation manual for registration.

Deregistering a handset

A handset can cancel its own registration to the base unit, or other handsets registered to the same base unit. This allows the handset to end its wireless connection with the system.

1 (middle soft key) #131

R All handsets registered to the base unit are displayed.

2MbN: Select the handset you want to cancel. a

3MbN: Yesa

R A confirmation tone sounds.

R The handset does not beep when cancelling its own registration.

4MN

Increasing the range of the base unit

You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 4. Contact your Panasonic dealer for details.

32

Page 32
Image 32
Panasonic KX-TG8163AL, KX-TG8162AL Registering a unit, Changing the base unit PIN Personal Identification Number