Panasonic LQ-MD800P manual Rear Panel

Control reference guide (continued)

Rear Panel

VIDEO		VIDEO IN
			S-VIDEO
Y	PB	PR
VIDEO		VIDEO OUT
1			S-VIDEO
	CH1(A)	CH2(B)	CH1	CH2
2
	AUDIO IN		AUDIO OUT		AUDIO
DV IN PAUSE					MON
					RS-232C
REMOTE

~ AC IN

USB

VIDEO IN (BNC)

Composite signal input.

VIDEO OUT 1/2 (BNC)

Composite signal output.

Y, PB, PR (Component Video output) (BNC)

Component signal (Y, PB, PR) output.

S-VIDEO IN (4P)

S-Video (Y/C) input.

S-VIDEO OUT (4P)

S-Video (Y/C) output.

DV IN (4-pin)

DV input. Connect a 4-pin IEEE1394 cable. You can digitally input video and audio.

PAUSE REMOTE (Stereo mini jack)

External control jack for recording start and pause control. This jack also outputs a recording status signal.

Audio CH1 (A)/CH2 (B) input connector (PHONO)

Input for analog audio. If you have connected a microphone, use the Audio CH assignment with Mic setting in the SETUP menus to assign recording channels.

Equipotential terminal

When connecting this unit to any other component, make absolutely sure that it is properly grounded by connecting this terminal.

When connecting, use the socket and be sure to use wire with a cross-sectional area of at least 1.0 mm2.

Cross-sectional area :

Security Lock

This can be used to connect a commercially-available theft-prevention cable (manufactured by Kensington). This security lock is compatible with the Microsaver Security System from Kensington.

Audio CH1/CH2 output connector (PHONO)

Analog audio output.

Audio Monitor output connector (PHONO)

Analog audio output. Use the Monitor setting item in the FUNCTION menus to assign the channel to be output.

More than 1.0 mm2

Power socket

Socket

RS-232C Remote connector (D-sub 9P)

RS-232C terminal. Connect a computer or other control device to enable external control.

USB Remote connector (Type-B connector)

Connect power cord (supplied).

USB terminal. Connect a computer or other control device to enable external control.

– 10 –