About Your Projector

Remote control

(17)

 

 

( 9 ) <VOLUME+/-> Buttons

 

 

 

Adjust the volume of the speaker. (Æpage 35)

(1)

(10)

(10)

<

> Button

 

 

 

Turn the projector on or off. (Æpage 29)

(2)

 

(11) <KEYSTONE> Button

 

 

Correct keystone distortion. (Æpage 33)

 

 

(12)

<INFO.> Button

 

 

 

Operate the [information] function. (Æpage 34)

(3)

 

(13)

<LAMP> Button

 

 

Select a lamp mode. (Æpage 35)

 

 

 

 

 

(14)

<P-TIMER> Button

(4)

(11)

 

Operate the [P-timer] function. (Æpage 35)

(15)

<IMAGE> Button

 

 

(5)

(12)

(16)

Select the image mode. (Æpage 35)

(6)

(13)

<MUTE> Button

 

Mute the sound. (Æpage 35)

(7)

(14)

(17)

Remote control signal emitter

 

 

 

 

 

(8)

(15)

Attention

 

(16)

zzDo not drop the remote control.

 

 

 

zzAvoid contact with liquids.

(9)

 

zzDo not attempt to modify or disassemble the remote

 

 

control.

 

Preparation

(1)<AUTO SETUP> Button

Execute the setting of Auto setup in the [setting] menu. (Æpage 52)

(2)Input Selection Buttons: <COMPUTER 1>, <COMPUTER 2>, <VIDEO>, <S-VIDEO>, <COMPONENT>.

These buttons are used to select the input signal. (Æpage 33)

(3)▲▼◄► Buttons, <SELECT> Button

Navigate the MENU display. (Æpage 36)

(4)<SCREEN> Button

Select a screen mode. (Æpage 48)

(5)<MENU> Button

Open or close the On-Screen Menu. (Æpage 36)

(6)<FREEZE> Button

Pause the projected image and sound tentatively. (Æpage 34)

(7)<AV MUTE> Button

Temporarily turn off the image on the screen. (Æpage 34)

(8)<D.ZOOM +/-> Buttons

Zoom in and out the images. (Æpage 35)

Note

zzThe remote control can be used within a distance of about 7 m (22.97 ft) if pointed directly at the remote control signal receiver. The remote control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control range may be reduced.

zzIf there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate correctly.

zzYou can operate the projector by reflecting the remote control signal on the screen. The operating range may differ due to the loss of light caused by the properties of the screen.

zzWhen the remote control signal receiver is lit with a fluorescent light or other strong light source, the projector may become inoperative. Set the projector as far from the luminous source as possible.

ENGLISH - 17