Preparation
UsingRemoteRemotecon rolcontrol
Installing and Removing batteries
1111Open the cover | 2222 Install batteries and close the cover |
| (Insert the – side first.) |
zzRemove the batteries in the reverse order of installation.
Setting Remote control ID numbers
When you use the system with multiple projectors, you can operate all the projectors simultaneously or each projector individually using single remote control, if unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control. There are 7 different ID codes (ALL, Code 1~Code 6), the initial ID number is [ALL].
JJ Setting the ID number
1)While holding down the <MENU> button, press the <IMAGE> button. The number of times you press the <IMAGE> button corresponds to the desired ID code number.
2)The number of times to press the <IMAGE> button is as follows: Code 1= Once, Code 2= Twice, Code 3= 3 times, Code 4= 4 times Code 5= 5 times, Code 6= 6 times
3)The ID code is changed when the <MENU> button is released.
4)The ID code is reset to [ALL] (default) by pressing the <MENU> button and <IMAGE> button at the same time for 5 seconds or more.
Attention
zzIf the <IMAGE> button is pressed 7 times or more, the ID code cannot be changed (the operation is invalid).
zzThe status of the ID code is not stored after replacing batteries.
MENU button
IMAGE button
20 - ENGLISH