Replacement
JJLamp unit
The lamp unit is a consumable component. You can check the total usage time using Lamp runtime in the [Information] menu on page 59.
It is recommended to ask an authorized engineer to replace the lamp unit. Contact your dealer. Consult your dealer to purchase a replacement lamp unit
CAUTION:
■Do not replace the lamp unit when it is hot. (Wait at least 45 minutes after use.)
The inside of the cover can become very hot, take care to avoid burn injuries.
JJNotes on the replacement of the lamp unit
zzThe luminous source of the lamp is made of glass and may burst if you hit it against a hard surface or drop it.
Please handle with care.
zzA Phillips screwdriver is required for replacement of the lamp unit.
zzWhen replacing the lamp unit, be sure to hold it by the handle.
zzWhen replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be broken.
zzIf replacing the lamp of a projector which has been installed
on the ceiling, you should always assume that the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice immediately.
zzThe lamp contains mercury. Consult your local municipality or your dealer about correct disposal of used lamp units.
Attention
zzDo not use other than designated lamp units.
zzThe part numbers of accessories and separately sold components are subject to change without notice.
JJWhen to replace the lamp unit
The lamp unit is a consumable component. Brightness decreases according to duration of usage, so periodical replacement of the lamp unit is necessary.
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and <LAMP> indicator lights yellow. Replace the lamp with a new one promptly.
Lamp run time | On screen | LAMP indicator |
| Lamp replacement icon |
|
The message is displayed for 10 seconds. If you
Over 3000 hours* press any button within the 10 seconds, the message disappears.
Maintenance
If the power is turned on without replacing the lamp,
Lights in yellow (even in
Over 3200 hours* the power automatically turns off after approximately ten minutes to prevent the malfunction of the projector.
*3200 hours of use is a rough guideline, but is not a guarantee. The lamp run time differs depending on the setting of "Lamp power" menu.
Note
zzThe Lamp replacement icon will not appear when the [Display] function is set to [Off ] (Æpage 53), or during [Freeze] (Æpage 34), or [AV mute] (Æpage 34).
ENGLISH - 63