Note

zzWhen selecting [Network], the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off.

zzRefer to "Operating Instructions - Network Operations". zzIf [Standby mode] is set to [Eco], you cannot use network functions when the projector is standing by. Also, you

cannot use some RS-232C protocol commands.

zzIf set to [Network], you can use network functions when the projector is standing by.

P-timer

This function allows you to change the setting of the [P-timer] and execute it.

1111Press ▲▼ to select [P-timer].

2222Press ► or <SELECT> button to access the submenu.

JJMode

1111Press ▲▼ button to select one mode among the items as below.

The [P-timer] display 000:00

Count up appears on the screen and the count up starts (000:00-180:00).

The time set in the [Timer] setting Count down appears on the screen and the

countdown starts.

JJTimer

1111Press ▲▼ to select [Timer] and then press the <SELECT> button.

2222Press▲▼ to set the [Timer](1-180 Min).

zzTimer is available in [Count down] only. Factory default value is 10 Min.

JJExecute

1111Press ▲▼ to select one among the items as below and then press the <SELECT> button.

Start It executes the [count up] or [count down] function.*1

Reset Reset the P-timer values.*2

Exit To exit the P-timer operation.

*****Press the <SELECT> button at [Start] and the indication changes into [Stop]. To stop [Count up] or [Count down], press the <SELECT> button at

Setting

[Stop] on the [screen] menu, then the indication changes into [Restart]. Press the <SELECT> button at [Restart] to resume [Count up] or [Count down].

*****Press the <SELECT> button at [Reset] to return to the following value:

Count up

"000:00"

Count down

Timer that you set

Attention

zzTo stop the [P-timer] function, press the <P-TIMER> button.

zzTo cancel the [P-timer], press and hold the <P-TIMER> button for a few seconds.

Closed caption

[Only for NTSC, 480i input]

1111 Press ▲▼ to select [Closed caption].

2222 Press ► or the <SELECT> button to enter the submenu.

JJClosed caption

1111 Press ▲▼ to select [Closed caption] and then press the <SELECT> button.

2222 Press ▲▼ to select [Off], [CC1], [CC2], [CC3] or [CC4].

JJColor

1111 Press ▲▼ to select [Color] and then press the <SELECT> button.

2222 Press▲▼ to select color or white.

Attention

zzThe closed caption is mainly used in the north America. This function shows the text information contained in the image signal. Captions may not be displayed on some devices or software.

zzYou can select [Closed caption] when [NTSC] or [480i] signals are input.

zzPart of characters may not displayed when high compensation valued are set in [Keystone].

zzClosed captions are not displayed while the menu screen appears.

Settings

ENGLISH - 55