Panasonic UB-5315 installation manual Replacing the Thermal Transfer Film

Replacing the Thermal Transfer Film

The unit is capable of producing about 15 more copies when the Contrast/Remaining Film Indicator begins to flash. The unit has run out of thermal transfer film and can no longer make copies when the Multi-Copy/Error Indicator flashes “ ”. Separately available replacement film (UG-6001) may be purchased from the dealer where you purchased the unit. Thermal transfer film is replaced as follows.

Notes on Replacing Thermal Transfer Film

•Only use the designated product (UG-6001) from Panasonic as the replacement film. (Note that using another type of replacement film may result in degraded printing quality or damage to the unit.)

•Thermal transfer film is disposable. Dispose of used thermal transfer film as “burnable” or “non- recyclable” rubbish.

•A negative of the copied image will remain on the thermal transfer film. To protect the security of your information, we recommend cutting up the used thermal transfer film with scissors or shredder before disposing of it.

1

2

Push down the printer open lever to open the printer door, and remove the used film.

Refer to steps 3 and 4 in the section of “Installing the Thermal Transfer Film” on pages 10, 11.

Notes

•If “ ” is still flashing after closing the printer door, make sure that the thermal transfer film has been installed properly and tightened.

•The printer door should be closed to make copies properly. Confirm both latches are locked.

16