Paper Jams

4

Install the thermal transfer film.

 

 

• Refer to steps 3 and 4 in the section of “Installing the

 

Thermal Transfer Film” on pages 10, 11.

 

• “ ” flashing on the Multi-Copy/Error Indicator will go

 

out.

Notes

If “ ” is still flashing after closing the printer door, make sure that the thermal transfer film has been installed properly and tightened.

The printer door should be closed to make copies properly. Confirm both latches are locked.

If the flashing does not go out after the foregoing procedure has been performed; this may indicate that the paper feeder is not functioning properly.

Reload the copy paper by following the steps given below.

1

ON

OFF

2

Turn the power off.

Open the paper cover and remove all the copy paper remaining inside the unit’s paper cover.

Note

The copy paper will slightly resist being removed, but may be pulled out without problems.

18

Page 18
Image 18
Panasonic UB-5315 installation manual Paper Jams, Install the thermal transfer film