Manuals / Brands / Power Tools / Work Light / Panasonic / Power Tools / Work Light

Panasonic 35, UJ30 5.1Hooking up the connection cable, Connection cable, 5 Getting started, 5.2Connecting the LED

1 69

Download 69 pages, 2.9 Mb

5 Getting started

After connecting the necessary cords, lastly plug in the power cord.

This section describes the steps up to turning on the power.

5.1Hooking up the connection cable

Plug the connection cable (for the LED head) into its connection port.

Connection cable

Plug the female side of the connection cable into the main unit. Plugging in

Warning

the wrong side (the male connector) could bend the connector pins or cause other issues.

5.2Connecting the LED

Connecting the head

LED head

Lens protector cap	Connector

Connection cable

Main unit side		LED side

ConnectorConnector

Contents

LED UV Curing System Aicure SPOT Type Safety Precautions for Users Laser products Preventive safety measures for users (summary) Safety features ■Remote interlock ■Control by a key switch ■LED radiation emission warning ■Emergency reset Labels ■Warning labels in Japanese (JIS) ■Description ■Warning labels in Chinese (GB standards) ■Warning labels in English (IEC/EN standards) Prohibited Mandatory Instruction Precautions for use ■General precautions ■Installation environment Ambient temperature Ambient humidity: Warranty Period Extent of Warranty Page Contents 1 Features of the ANUJ 3000/3500 ■High-powerirradiation: 10,000 mW/cm2 (with ANUJ6423 lens) initial value) ■UV curing without temperature increases ■UV intensity stabilization Features of the ANUJ 3000/3500 The ■Universal design for easy operation ■Multiple safety features ■Detachable terminal blocks for external connection ■Universal power supply 2 Part names and functions Controller Optional parts (sold separately) Front of the controller UV sensor (option) Rear of the controller AC adapter ●Front 4.1Installation conditions 4.2 General guidelines for irradiation distance and UV intensity Page 5.1Hooking up the connection cable Connection cable Getting started <Procedure 1.Plug in the connection cable 2.Connect the LED head to the connection cable 3.Remove the protective cap from the LED head 5.3Connecting the external control signals 5.4 Connecting the AC adapter 5.5Power-onoperation 6.1Operation mode (default mode when power is turned on) Operation modes Page Page 6.2UV measurement and Auto tuning mode Page 6.3Default settings mode 6.4Timing chart Page Page Page 7.1External input/output control External control Output Specification ・Rated load voltage: 5 V DC to 28 V DC ・Max. load current: 100 mA (per 1 output) ・Maximum voltage drop is less than 0.9 V when output is given 7.2Serial communication control Page Page Page 7.3Communications address map Page Page Page Page Page Page Page Page 7.4Setup tool application for UJ35 Page Page Page Page • LED status for each CH differentiated by color • When irradiation is possible, READY ON is highlig hted • If an error occurs, an error number is displayed • Panel showing error list can be displayed at any time • During irradiation START is highlighted Page 8 Warning indications ■Temperature warning ■Error codes 9.1Safety circuit 10.1Outline of specifications Specifications 11 Dimensions Page Page 12.1Options and spare parts Option and spare parts list 12.2How to replace the lens unit 12.3Fitting the mounting bracket Troubleshooting Manual revision history