Panasonic 35, UJ30 33

Operation modes

*1) It is not possible to select a particular channel unless it has an LED head connected to it.

*2) Conditions under which the signals below are set to ON.

-READY ALL: ON when CHs are selected on the front panel of the controller, and all selected channels are ready*3) for irradiation.

-READY1-4: ON when the corresponding CH is ready for irradiation. Note that even if the CH is not selected on the front of the controller, if the channel is ready*3) for irradiation, the signal will be ON.

-BUSY1-4: ON while irradiation is in progress on the corresponding channel.

*3) Irradiation-ready state

-The INTERLOCK input on the rear of the controller is set to ON.

-Irradiation conditions (intensity and time) have been set, and the 1STEP time value is not set to 0.

Contents

LED UV Curing System Aicure SPOT Type Safety Precautions for Users Laser products Preventive safety measures for users (summary) Safety features ■Remote interlock ■Control by a key switch ■LED radiation emission warning ■Emergency reset Labels ■Warning labels in Japanese (JIS) ■Description ■Warning labels in Chinese (GB standards) ■Warning labels in English (IEC/EN standards) Prohibited Mandatory Instruction Precautions for use ■General precautions ■Installation environment Ambient temperature Ambient humidity: Warranty Period Extent of Warranty Page Contents 1 Features of the ANUJ 3000/3500 ■High-powerirradiation: 10,000 mW/cm2 (with ANUJ6423 lens) initial value) ■UV curing without temperature increases ■UV intensity stabilization Features of the ANUJ 3000/3500 The ■Universal design for easy operation ■Multiple safety features ■Detachable terminal blocks for external connection ■Universal power supply 2 Part names and functions Controller Optional parts (sold separately) Front of the controller UV sensor (option) Rear of the controller AC adapter ●Front 4.1Installation conditions 4.2 General guidelines for irradiation distance and UV intensity Page 5.1Hooking up the connection cable Connection cable Getting started <Procedure 1.Plug in the connection cable 2.Connect the LED head to the connection cable 3.Remove the protective cap from the LED head 5.3Connecting the external control signals 5.4 Connecting the AC adapter 5.5Power-onoperation 6.1Operation mode (default mode when power is turned on) Operation modes Page Page 6.2UV measurement and Auto tuning mode Page 6.3Default settings mode 6.4Timing chart Page Page Page 7.1External input/output control External control Output Specification ・Rated load voltage: 5 V DC to 28 V DC ・Max. load current: 100 mA (per 1 output) ・Maximum voltage drop is less than 0.9 V when output is given 7.2Serial communication control Page Page Page 7.3Communications address map Page Page Page Page Page Page Page Page 7.4Setup tool application for UJ35 Page Page Page Page • LED status for each CH differentiated by color • When irradiation is possible, READY ON is highlig hted • If an error occurs, an error number is displayed • Panel showing error list can be displayed at any time • During irradiation START is highlighted Page 8 Warning indications ■Temperature warning ■Error codes 9.1Safety circuit 10.1Outline of specifications Specifications 11 Dimensions Page Page 12.1Options and spare parts Option and spare parts list 12.2How to replace the lens unit 12.3Fitting the mounting bracket Troubleshooting Manual revision history