7.1External input/output control
■External control connectors (12 pin × 2) MINI COMBICON Plug 12P
(PHOENIX CONTACT: MC
(Osada:
Compatible wiring (stranded)
| Size |
|
| Conductor section area |
|
|
|
|
|
|
|
|
|
|
|
| |||
|
| 0.2 - 1.25 mm2 |
|
|
| ||||
|
|
|
|
|
| ||||
Warning | Tightening torque: 0.22 to 0.25 Nm |
| Precautions for wiring |
・Carefully strip the cover so as not to damage the core wires.
・Connect the core wires without twisting them.
・Connect the core wires without soldering them; otherwise, they may break due to vibration.
・After connection, do not apply stress to the cable.
・Because of the terminal structure, if the wire is tightened by a counterclockwise rotation, the connection will fail. In such cases, pull out the wire, check the terminal hole, and then connect it again.
■Input/output terminal table
INPUT
Pin No | Signal name | Description |
| ||
1 | START | 1 | CH1 irradiation start signal |
| |
2 | START | 2 | CH2 irradiation start signal |
| |
3 | START | 3 | CH3 irradiation start signal |
| |
4 | START | 4 | CH4 irradiation start signal |
| |
5 | TYPE | Chg1 | Product type switching signal |
| |
6 | TYPE | Chg2 | Product type switching signal | UJ35 only | |
7 | TYPE | Chg3 | Product type switching signal | ||
| |||||
8 | UV CHECK | UV intensity control mode signal |
| ||
9 | STOP |
| Irradiation stop signal, Error reset |
| |
10 | START ALL |
| |||
11 | INTERLOCK | Interlock (normally ON) |
| ||
12 | COM |
| Common terminal for input/output signals |
| |
OUTPUT
Pin No | Signal name | Description |
|
13 | READY ALL | ON when irradiation is ready to start |
|
14 | READY1/BUSY1 | ON when CH1 irradiation is ready to start/in progress | READY/BUSY |
15 | READY2/BUSY2 | ON when CH2 irradiation is ready to start/in progress | singal is changed |
16 | READY3/BUSY3 | ON when CH3 irradiation is ready to start/in progress | over by changing the |
17 | READY4/BUSY4 | ON when CH4 irradiation is ready to start/in progress | initial setting mode. |
| |||
18 | ERROR | Error signal |
|
19 | ALARM | Warning signal (temperature/time warning) |
|
20 | COM | Common terminal for input/output signals |
|
21 | COM | Common terminal for input/output signals |
|
22 | FG | Frame gland |
|
23 | +5V | 5 V DC output (for display or output signals) |
|
24 | COM | Common terminal for input/output signals |
|
* Pin Nos. 12, 20, 21 and 24 are connected internally.
Warning The ON time of input signal pulses must be 100 ms or more.
24