・Never connect any LED head, connection cable, AC adapter, or UV sensor to the main unit, other than those designated by Panasonic. Otherwise, any failure, loss, or damage that may occur will not be covered under warranty.
・Never try to disassemble or modify the product, or to alter its internal settings. Any failure or damage that occurs after disassembling or modifying the product will not be covered under warranty.
■Installation environment・ | Ambient temperature | Controller: 0 to +35°C (with no condensation) |
|
| LED head: +5 to +35°C (with no condensation) |
・ | Ambient humidity: | 30 to 85% RH (at 25°C, with no c ondensation) |
・A location free of dirt, smoke or soot, conductive dust, and corrosive or flammable gases, where there is no risk of exposure to water, oil, or chemicals
・A location not subject to sudden temperature changes, or to vibration and physical shock
・A location not exposed to direct sunlight■Power supply・Supply electric power of 100 to 240 V AC (frequency: 50/60 Hz).・Supply electric power of 5 to 28 V DC to the input/output terminals.・The supplied power cable is for use in Japan, at 100 V. If using this product outside Japan, make sure to use a suitable cable with the appropriate plug, certified for use in the particular country.
・Do not connect this product to a power supply that is shared with equipment that includes an electric motor or other
・If using multiple units of this product, do not tie their AC adapters together in a bundle. Otherwise, the AC adapters may overheat, resulting in failure.
・If the product is to remain unused for any length of time, disconnect the power plug from the power socket.
■Wiring・If any device connected to this product is connected to a DC induction load (motor or relay), connect a noise absorption device (e.g., noise suppressor) on the side of the load.
・When connecting an external power source to the input/output terminals, make sure that the polarity is correct.
・Make sure to perform wiring so that no physical or electrical load is added to the connection cable. Also, avoid bending too close (less than 80 mm) to the base (connector part) and make sure that the radius of bends is at least 33 mm.
・Make sure to hold the connector (plug) part while connecting or disconnecting the power plug.
■If the connection cable is longer than 2 m, or if the product is installed inside a larger item of equipment, set up a display near the LED head so that the “LED radiation warning” can be readily seen. If you use OUTPUT terminals “+5V” (23) and “C OM” (24) at the rear of the controller, these will output a signal when the power is switched ON.
vii