Panasonic WJ-RT208 manual Rear View

■Rear View

e w !5 !4

	ON
	OFF
	POWER	AC IN				AUDIO OUT	2	3	AUDIO IN	5	6	7	8
						1			4
	SIGNAL GND			TERMINAL/CONTROL
						1	2	3	4	5	6	7	8
	MODE DATA 10/100BASE-T		COPY1	SERIAL	MONITOR(VGA) VIDEO OUT				VIDEO IN
q	rt y u		i	o !0 !1		!2			!3

qPower Cooling Fan

Prevents the temperature of the recorder from rising. Do not block the ventilation openings.

wAC Power Connector (AC IN)

Connect the supplied power cable to this AC power connector.

ePower Switch (POWER)

This switch turns the power of the disk recorder on and off.

rSignal Ground Terminal (SIGNAL GND)

tMode Selection DIP switches (MODE)

This 2-bit DIP switch is used for setting the terminal sys- tem. Refer to DIP Switch Setting for details.

yData Port (DATA)

This port is for data communication with external devices.

u10Base-T/100Base-Tx Port (10/100BASE-T)

This port is used to exchange control data with Ethernet via an Ethernet Hub.

iCopy Port (COPY1)

This port is used to connect an external hard disk to back up the data recorded on the hard disks.

oSerial Data Port (SERIAL) For servicing purpose only.

!0Terminal/Control Port (TERMINAL/CONTROL)

This port controls terminal inputs 1-8 and alarm outputs 1-3. It is also used to connect component cameras with the RS485 protocol feature.

!1VGA Output Port (MONITOR (VGA))

When a VGA monitor is connected to this port, the same image as supplied from the video output terminal is obtained.

!2Video Output Connector (VIDEO OUT)

Spot live, split-screen, and playback pictures are output from this BNC connector. All menu settings and screen display information are also output from this connector.

!3Video Input Connectors (VIDEO IN 1-8)

System cameras or component cameras are connected to these BNC connectors. A 75 Ω termination is made unless the video output terminal is connected.

!4Audio Input Connectors (AUDIO IN 1-8)

These are used for BNC standard jacks. Each of them accept an unbalanced –10 dBV, 22 kΩ line input audio signal supplied from an external device.

!5Audio Output Connector (AUDIO OUT)

This is used for a BNC standard jack that supplies an unbalanced –10 dBV, 22 Ω line output audio signal to an external device.

10