1.4 Modification of the System Time

When this unit is used for the first time, set up the system time with the procedures specified below. This system time should be checked periodically. If it seems to be incorrect, readjustments are needed.

(1) Click the [MENU] button to display the setting menu.

WJ-RT208 SETUP MENU

SYSTEM MANAGEMENT

SEARCH

REC&EVENT SETUP

PTZ SETUP

CAMERA SETUP

COMMUNICATION SETUP

REPORT

USER INFORMATION

DATA MANAGEMENT

(2)Move the cursor to "SYSTEM MANAGEMENT" and press the [SET] button.

The "SYSTEM MANAGEMENT" menu appears.

SYSTEM MANAGEMENT

SYSTEM SETUP

DISK INFORMATION

REBOOT SYSTEM

PICTURE ADJUST

TIME & DATE

VERSION

(3)Move the cursor to "TIME & DATE" and press the [SET] button.

"TIME & DATE" menu appears.

TIME & DATE

YYYY-MM-DD HH:MM:SS

2005-01-28 10:43:38

OK

 

Cancel

Move the cursor to the correcting position.

(4)Enter the local time by using Buttons [0] - [9].

(5)Move the cursor to [OK] and press the [SET] button.

(6)End of setting

When the [ESC] button is pressed several times, the screen returns to the previous menu "SYSTEM MAN- AGEMENT".

Note: If time is corrected in the middle of recording, part of the recorded data may fail to be played. This is because some turbulence can arise in the record start time and the end time.

1.5 Turning the Power Off

The power supply for this unit cannot be turned off if hard disk data are being played or data are being recorded on the hard disk. Operation for playback or recording has to be stopped first. Turn off the power supply after confirming that the HDD indicator of the front panel is not lit.

(1) Stop the manual recording.

Select the desired image to be stopped by using the camera selection button (1 - 8) or the direction button (up/down).

Hold down the [STOP] button for 2 seconds.

The Record indicator of the numerical keys goes off and recording is stopped.

For timer recording, alarm recording, or motion detector recording, set up "On" or "Off" for each one with "WJ- RT208 SETUP MENU" – "REC&EVENT SETUP", and then stop recording in the above procedures.

(2) Stop playback.

Select channel 1 by using the camera selection button (1 - 8) or the direction button (up/down), and press the [STOP] button. Playback is stopped.

(3) Turn off the power switch on the rear panel.

Turn off the power supply after confirming that the HDD indicator of the front panel is not lit.

Check the [OPERATE] indicator. If this indicator is not lit, the power supply has been turned off.

Note: If this unit is not used for a long time, pull out the power cord from the power connector.

25

Page 25
Image 25
Panasonic WJ-RT208 manual Modification of the System Time, Turning the Power Off, Time & Date YYYY-MM-DD Hhmmss, Cancel