Off: Does not change the image quality upon alarm detection.
Default: Off
[Image quality upon alarm detection]
Image quality can be changed upon an alarm occur- rence. Select the image quality from the following.
0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low Default: 5 Normal
Configure the VMD settings [VMD area]
Click the [VMD area] tab on the "Alarm" page. (☞ Pages 13 and 14: How to display/operate the setup menu) The video motion detection areas can be set on this page.
Up to 4 areas can be set. When motion is detected in the set area, it will be regarded as an alarm.
Important:
•The alarm occurrence indication button (☞ page 8) will be displayed when motion is detected by the VMD func- tion.
•The alarm occurrence indication button will be displayed when receiving an alarm input of a command alarm
•Depending on the network environment, notification may be delayed even when "Real time" is selected for
"Alarm status update mode" on the "Basic" page (☞ page 18).
•The motion detection function is not the dedicated function to prevent thefts, fires, etc. We are not responsible for any accidents or damages occurring in case.
[Area]
When selecting a VMD area in the screen, it will be numbered as area 1.
[Status]
Select "On" or "Off" to determine whether or not to activate each VMD area.
On: Activates the respective VMD area.
Off: Inactivates the respective VMD area.
Default: Off
[Detection area]
Adjust the size of the VMD area using the slider. The smaller the selected value is, the higher the sensitivity of VMD area becomes. The current value
Default: 1
[Detection sensitivity]
Adjust the sensitivity of motion detection in the VMD area using the slider. The settings can be configured for each area individually. The larger the value is set, the higher the sensitivity level becomes.
The current value (1 (low) - 15 (high)) will be displayed below the slider.
Default: 8
[Delete] button
Click the [Delete] button corresponding to the area to be deleted. The outline of the selected area will be deleted.
33
