Traps & MIBs

Extension to Interfaces Table (RFC 1573)

This extension contains additional objects for the Interface table. Table C-4 shows the objects supported.

Table C-4. Extension to Interfaces Table

Object

Description

Setting/Contents

 

 

 

ifName

Provides the name of the

Specifies the interface name:

(ifXEntry 1)

interface.

H dsl1 ± DSL interface.

 

 

 

 

H eth1 ± Ethernet interface.

 

 

 

ifHighSpeed

Displays the downstream

Depending on the current mode of operation, displays the speed in

(ifXEntry 15)

speed for the DSL or

1 million bits per second (Mbps) of the Ethernet interface as:

 

Ethernet interface in Mbps.

H 10 Mbps

 

 

 

 

H 100 Mbps

 

 

Due to the speed displaying as Mbps, the DSL interface downstream

 

 

speed displays as 0 (zero).

 

 

 

ifConnector

Indicates whether there is

The value for all interfaces is always:

Present

a physical connector for

H true(1)

(ifXEntry 17)

the interface.

 

 

 

 

IP Group (RFC 1213)

The Internet Protocol Group objects are supported by the unit for all data paths that are currently configured to carry IP data to/from the unit. All of the objects in the IP Group, except for the IP Address Translation table, are fully supported. Table C-5provides clarification for objects contained in the IP Group.

Table C-5. IP Group Objects (1 of 2)

Object

Description

Setting/Contents

 

 

 

ipForwarding

Specifies whether the unit is acting

The value is read-only and always displays: (1)

(ip 1)

as an IP gateway for forwarding of

 

 

datagram received by, but not

 

 

addressed to, the DSL router.

 

 

 

 

ipDefaultTTL

TTL = Time To Live.

Minimum value ± 15. Maximum value ± 255.

(ip 2)

 

H 64 ± Default.

 

 

 

 

 

ipAddrTable

The address table.

The device sets the object ipAdEntReasmMaxSixe to

(ip 20)

 

16384. Supported as read-only.

 

 

 

6371-A2-GB20-10

August 2000

C-7

Page 79
Image 79
Paradyne Routers manual Extension to Interfaces Table RFC, IP Group RFC