Pelco C1570M-E (4/07) manual Configure a CM9700 Macro to Switch Video to a Backup NVR

CONFIGURE A CM9700 MACRO TO SWITCH VIDEO TO A BACKUP NVR

1.Use the CM9700-MGR software to add a macro, and then click Edit Steps to open the Macro Editor window. Refer to the Macros section in the CM9700-MGR Software Guide for detailed instructions.

Figure 39. Adding a Macro for NVR Management

2.In the macro command tree, click Camera, and then double click the SWT (switch) command. The command is added as a step in the macro step grid.

3.Specify the monitor number and the camera number in the parameter fields.

4.Repeat steps 2 and 3 for each camera connected to the NVR.

Figure 40. Sample Macro for NVR Management

5.Click Close to save the macro and close the Macro Editor window.

6.Repeat steps 1-5 for each NVR.

36 C1570M-E (4/07)