12 C1570M-E (4/07)
MOUNTING
Use one of the following installation methods for the CM9700MDD-EVS:
•
Place the CM9700MDD-EVS on a flat surface, such as a shelf or desktop
•
Mount the CM9700MDD-EVS to a wall using the optional WM5001-4U wall mount kit
•
Install the CM9700MDD-EVS in the optional RK5000PS-5U rack mount kit.
NOTES:
•
Each installation method, except the RK5000PS-5U mounting, requires the installation of a separate power supply (NET5301PS).
•
When installing the CM9700MDD-EVS on a desktop, use the rubber feet provided with the CM9700MDD-EVS to protect the desktop from
surface damage. The rubber feet are not needed when mounting the CM9700MDD-EVS in a wall or rack mount.
•
Be sure the distance from the CM9700MDD-EVS to the matrix bay video input connector is less than the maximum distance for the coaxial
cable. Refer to Table B on page 17 for maximum video coaxial cable distances.
DESKTOP INSTALLATION
To place the CM9700MDD-EVS on a flat surface, such as a desktop:
1. Attach the rubber feet to the bottom of the unit to prevent surface damage (refer to Figure 5).
Figure 5.
Installing Rubber Feet for Desktop Placement
2. Position the unit to allow for cable and power cord clearance at the front and rear panels.
Figure 6.
CM9700MDD-EVS Desktop Placement
WARNING:
Do not place the CM9700MDD-EVS on its side; the unit could fall over and cause damage.
RUBBER FEET