Pelco C624M-C (5/06) manual

144 C624M-C (5/06)
Figure 108. Network Setup Page
Setting Up DHCP
Your network must support DHCP and an active DCHP server must be present for dynamic addressing to work. If you select DHCP and your
network does not include an active DHCP server, the IP address settings will default to addresses in the 169.254.x.x range. Consult your network
administrator for more information.
Access the Network page to set up the DHCP options. For information on accessing the Network page, refer to Setting Up DX8000 Network
Access on page 143.
To configure the DVR to acquire a dynamic IP address through DHCP:
1. In the Network page, click the check box labeled Obtain An IP Address Automatically (DHCP).
2. Click Apply.
Setting Up a Static IP Address
The DX8000 allows you to set up a static IP address. This information can be obtained from your network administrato r.
Access the Network page to set up the static IP address. For information on accessing the Network page, refer to Setting Up DX8000 Network
Access on page 143.
To set up a static IP address:
1. In the Network page, verify that the Obtain An IP Address Automatically (DHCP) check box is not selected.
2. In the IP Address box, enter a unique IP address (for example, 10.10.0.170). The last three digits must be d ifferent for each recorder (for
example, 171, 172, 173, and so forth).
3. In the Subnet Mask box, enter the subnet mask (for example, 255.0.0.0 is the default).
4. In the Default Gateway box, enter the gateway address (the IP address of the default router on your immediate network segment).
5. Click Apply.
 