UltraPort Serial Adaptors User Guide
Installing under SCO OpenServer and OpenServer6 Page 46
Chapter 2 Installing drivers and host cards
General installation procedure for SCO OpenServer
The general procedure for installing and configuring host cards, drivers software and
associated utilities for the SCO OpenServer operating system is as follows:
1. Install any UltraPort, UltraPort SI, and UltraPort Express cards you require into your
system. See Installing host cards and cable accessories on page 95
2. Install the SPEED SCO OpenServer drivers and utilities onto your system using the
procedures described in Installing device drivers and utilities on page 47.
3. If required, remove any host cards you want from your system. See Removing host
cards on page 101.
4. Using the Port Configuration tool, configure the serial ports you have added to the
system. See Configuring serial ports on page 53.
Your system can now use the serial adaptor cards you have installed. If required, you can
reconfigure serial ports following initial installation.