Adjustment
11.05.12 Knife(On Model 1246 make these adjustments on both knives.)Requirement
1.The elongated hole of knife 3 must be parallel to knife carrier 5 and the knife must not be touching the casting (see arrow).
2.When the point of needle catcher 4 protrudes approx. 3 mm over the cutting edge of the knife, knife 3 must just touch thread catcher 4.
3 2 5
4
1
Fig. 11 - 27
● Loosen screws 2.
● Move knife 3 in such a way that it cannot collide with thread catcher 4.
●Taking care to ensure that screw 1 is loosened, manually turn thread catcher 4 in accordance with requirement 2.
●Bring knife 3 to rest against thread catcher 4 and align it in accordance with requirement 1.
●In this position tighten screws 2.
●Screw 1 remains loosened for the following adjustment.
11 - 31