Philips 44PL9522, 44PL9773, 55PL9773 setup guide Programming the Remote Control, Vcr Dvd

Programming the Remote Control

Your TV remote control can operate accesso- ry devices such as cable boxes, VCRs, DVD players, satellite receivers, and amplifiers.

Normally, the remote is in TV mode. You must press the Select button to switch the remote to one of the accessory modes—CBL, VCR, DVD, SAT, or AMP.

AMP

It is likely you will need to program you remote, but, before you do, try this test:

•Press the Select button repeatedly until the mode you desire lights up. When the light begins blinking, point the remote toward the accessory device, then press the Standby–On button. If the device responds you do not need to program the remote. If not, follow the steps below to program the remote.

1 Look up the number for the device on the list below:

GUIDE

POWER SELECT POWER

INFO

HIGH DEFINITION

SAT

DVD619 DVD/CD PLAYER

OPEN/CLOSE

STANDBY-ON

DVD

STOP PLAY PAUSE

PREVNEXT

1Cable (CBL)

2VCR

3DVD

4Satellite (SAT)

5Amplifier (AMP).

Look up the number for the manufac- turer on pages 24–25.

2 Press the Select and Standby–On but- tons at the same time, then release.

3 Press the number for the device fol- lowed by the manufacturers code. The green Standby-On light will blink, indicating the code is valid. If the light does not blink, start again at step 1 using another code (if available).

VCR

CBL

2

2

3

22