PictureTel III ISA manual Configuration, Under Windows, AutoLink Requirements

4	SOFTWARE INSTALLATION
	AND CONFIGURATION

UNDER WINDOWS 3.X

This chapter describes how to install NIC software and configure the NIC under DOS, Windows 3.1, or Windows for Workgroups. If your PC is running Windows 95 or Windows NT, go to Chapter 2 and Chapter 3.

Installing NetWare Drivers for DOS, Windows 3.1, and Windows for Workgroups

This section describes how to use the AutoLink program to install client and driver software for DOS environments and Novell NetWare 3.1x or 4.1x under Windows 3.1 and Windows for Workgroups.

When your system administrator configures a 3Install account on your server, the AutoLink program logs on to the server and updates the client software. AutoLink creates a new AUTOEXEC.BAT file and saves the old file as AUTOEXEC.3CM. AutoLink also creates a new CONFIG.SYS file and saves the old file as CONFIG.3CM.

AutoLink Requirements

The AutoLink program includes an installation program. To use the AutoLink program, your PC should have only one 3C509B NIC installed and a minimum of 1 MB of available hard disk space.

Running the AutoLink Install Program

Follow these steps to run the installation program to configure the NIC:

1Install the NIC and connect it to the network, as described in Chapter 1.

2Reboot to DOS.

3Insert EtherDisk diskette 2 in drive A.

4Run the installation program. At the DOS prompt, enter: a:install

The main menu is displayed, as shown in Figure 4-1.