Pioneer DEH-P85BT Storing and recalling broadcast frequencies, Using the remote control

	Section
Operating this unit	02

Non-RDS or MW/LW

  

1Band indicator

2Stereo (5) indicator

Shows when the selected frequency is being broadcast in stereo.

3LOC indicator

Shows when local seek tuning is on.

4Preset number indicator

5Frequency indicator

1Press SOURCE to select the tuner.

2Press BAND to select a band.

Press BAND until the desired band is dis- played, FM-1, FM-2, FM-3 for FM or MW/LW.

3To perform manual tuning, push MULTI-CONTROL left or right.

4To perform seek tuning, push and hold MULTI-CONTROL left or right for about one second and release.

The tuner will scan the frequencies until a broadcast strong enough for good reception is

found.

# You can cancel seek tuning by pushing

MULTI-CONTROL left or right.

# If you push and hold MULTI-CONTROL left or right you can skip stations. Seek tuning starts as soon as you release MULTI-CONTROL.

Note

Listening MW radio while connecting iPod to this unit may generate noise. In this case, disconnect iPod from this unit and noise is disappeared.

Storing and recalling broadcast frequencies

You can easily store up to six broadcast fre- quencies for later recall.

!Up to 18 FM stations, six for each of the three FM bands, and six MW/LW stations can be stored in memory.

1When you find a frequency that you want to store in memory press LIST.

2Use MULTI-CONTROL to store the se- lected frequency in memory.

Turn to change the preset number; press and hold to store.

The preset number you have selected will flash and then remain lit. The selected radio station frequency has been stored in memory.

3Use MULTI-CONTROL to select the de- sired station.

Turn to change the station; press to select.

# You can also change the station by pushing

MULTI-CONTROL up or down.

# If you do not operate the list within about 30 seconds, the display is automatically returned to the ordinary display.

Using the remote control

%When you find a frequency that you want to store in memory, press one of pre- set tuning buttons 1 to 6 and hold until the preset number stops flashing.

The number you have pressed will flash in the preset number indicator and then remain lit. The selected radio station frequency has been stored in memory.

The next time you press the same preset tun- ing button the radio station frequency is re-

called from memory.

# You can also recall radio station frequencies assigned to preset tuning numbers by pushing MULTI-CONTROL up or down during the fre- quency display.

English

En 13