Editing the disc
VR mode
NOTES:
¥It is no problem to omit the procedures for confirming the scene or adjusting start and end points.
¥It is not possible to make any adjustments for 2 seconds after a title starts or 2 seconds before it ends.
¥To set a start point at the beginning of a title, set it during countdown.
¥The points during editing may be different from the preview.
¥Start and end points are adjusted in units of 1 second.
06
5Press 
or 
to select ÒSET STARTÓ at the start point of the scene that you want to erase and press ENTER. (To set the start point easily, search the start point while ÒSET STARTÓ is selected) The still image at the start point appears at the left small screen.
+(()*,!%&' )* 
!"#
6Press 
or 
to select ÒSET ENDÓ at the end point of the scene you want to erase and press ENTER.
The still image at the end point appears at the right small screen.
!" | '()*+ | *+#+$,'! | ! | ||||
| |||||||
| |||||||
7Check the erased scenes.
¥Select ÒPreviewÓ and press ENTER. Then the video where the scenes between the start and end points are erased is played back.
¥Each operation button (F.FWD, REW, SKIP 6, SKIP 7, PLAY, PAUSE/STILL) for playback also can be used.
8Adjust the start and end points.
¥To adjust the start point, select ÒAdjust startÓ and press ENTER. You can change the start point every one frame by
pressing 
or 
.
¥To adjust the end point, select ÒAdjust endÓ and press ENTER. You can change the end point in the same way as the start point.
9If you determine the scene to be erased, press 
or 
to select ÒFinishÓ and press ENTER.
¥A chapter mark is automatically added at the location of the erased scene.
67
En
2H30301B_En_64_71 | 67 | 8/4/05, 19:25 |
