02Various settings

Automatic TV tuning and clock setting

Plug in your unit into the mains supply and it will start to automatically tune itself in and set the correct date and time. After setting itself up, you must set the TV to the video channel.

ONLY WHEN YOU PLUG IN THIS UNIT FOR THE FIRST TIME, THE AUTOMATIC SETUP WILL BE AVAILABLE.

AV3

STANDBY/ON

CHANNEL + / –

Preparation:

¥Make sure that your unit is connected properly to the TV.

¥If a satellite receiver is connected with the coaxial lead, make sure itÕs switched ON and set to SKY ONE.

¥Turn on the TV and select the channel you wish to allocate for video use.

1Plug in your unit's plug into the mains supply. ÒAutoÓ will start to flash in the unit display. And also ÒAUTO TUNINGÓ will be displayed on the TV screen. Your unit will automatically tune itself in and set the correct time and date (Depending on the reception condition, it may take approx. 10 minutes.)

2Press and hold the

STANDBY/ON button on the front of your unit in the Standby mode until RF output channel Ò36Ó will appear in the unit display.

3If you have used a 21 pin scart lead you now, simply select the AV channel on your TV and go to step 5. Tune the TV in the same way

as tuning in a TV broadcast station until the word

ÒTESTÓ flashes on the TV screen. Refer to the TV operating instructions for tuning. Now the output

18from the unit is tuned to this channel. Whenever

En

you want to play back a tape, select this channel.

4If there is interference from an adjacent broad- cast channel in the picture (wavy lines, picture roll, etc.), press the CHANNEL + / – buttons on your unit to select any other RF channel between 23 and 69, retuning your TV until the word ÒTESTÓ flashes on the TV screen. If you con- nected a satellite receiver as explained on page 16, you must switch off the VCRÕs transmitter. Press the unitÕs CHANNEL + / –

buttons repeatedly until OFF appears in the display window (OFF

will appear after 69 or before 23).

5Press the STANDBY/

ON button to turn OFF the unit. Now the TV is tuned to your unit.

NOTES:

¥The unit automatically corrects the clock setting every hour and automatically adjusts the clock setting for Daylight Saving Time.

¥Your unit will tune the TV stations as follows.

CH 1

BBC 1

CH 5

Channel 5

CH 2

BBC 2

CH 6

Satellite

CH 3

ITV

CH 7

etc.

CH 4

Channel 4

 

 

¥If you want to change the RF output channel or switch to ÒOFFÓ, press and hold the STANDBY/ON button on the front of your unit in the Standby mode until the current RF output channel appears. Press the CHANNEL + / – buttons on your unit to select the RF channel you desire.

2H30301B_En_18_29

18

8/4/05, 19:20

Page 18
Image 18
Pioneer DVR-RT501-S operating instructions Automatic TV tuning and clock setting, Various settings, Preparation, Bbc, Itv