Setting up | 08 |
Power Management (PC source only)
The system will be automatically placed into the standby mode when no signal is received from the PC.
1Press HOME MENU.
2Select “Power Control” (/ then ENTER).
3Select “Power Management” (/ then ENTER).
4Select “Mode1” or “Mode2” (/ then ENTER).
Power Management
Selections | Off (default) | No power management |
|
|
|
| Mode1 | • Places the system into the standby mode |
|
| when no signal is received from the |
|
| personal computer for eight minutes. |
|
| • Even when you start using the computer |
|
| and a signal is received again, the system |
|
| stays off. |
|
| • The system is switched on again by |
|
| pressing STANDBY/ON on the plasma |
|
| television or on the remote control unit. |
|
|
|
| Mode2 | • Places the system into the standby mode |
|
| when no signal is received from the |
|
| personal computer for eight seconds. |
|
| • When you start using the computer and a |
|
| signal is input again, the system is |
|
| switched on. |
|
| • The system is switched on again by |
|
| pressing STANDBY/ON on the plasma |
|
| television or on the remote control unit. |
|
|
|
5 Press HOME MENU to exit the menu.
Note
•This function is not selectable when the PC is connected to the HDMI terminal.
37
En
