Pioneer RCS-LX60D Device connected to the USB port is not recognized, File names are not, Output

Additional information 16

ProblemRemedy

The device connected to the USB port is not recognized

•Check that the device is compatible with this recorder (page 55).

•Use a USB cable less than 5 m in length.

•Check that the USB cable is inserted fully.

•Check that the USB device is powered on.

•Try switching this recorder into standby mode and then back on.

•Try using the Restart USB Device option from the Initial Setup menu (page 145).

•If several USB devices (camera, USB memory, card reader, etc.) are connected at the same time, it’s possible that only the first device connected to this recorder will be recognized.

File names are not	• Files names that do not conform to the ISO8859-1 standard may not display correctly on
displayed properly.	this unit.

HDMI

Problem

The connected HDMI or DVI device does not display any picture (and the front panel HDMI indicator does not light)

Remedy

•Try disconnecting then reconnecting the HDMI cable (while the power of both components is on).

•Try switching the power of the HDMI/DVI device off then back on.

•Try switching off the HDMI/DVI device and this recorder. Next, switch on the HDMI/DVI device and leave it for around 30 seconds, then switch on this recorder.

•When you connect an HDMI-compatible device make sure of the following:

–The connected device’s video input is set correctly for this recorder.

–The cable you’re using is fully HDMI-compliant. Using a non-standard cable may result in no picture being output.

–Don’t use several HDMI cables connected together. Use a single cable to connect devices together.

•When you connect a DVI-compatible device make sure of the following:

–The connected device’s video input is set correctly for this recorder.

–The DVI terminal on the connected device is HDCP-compatible.

–The connected device is compatible with NTSC (720 x 480i/p, 1280 x 720p, 1920 x 1080i/p) and PAL (720 x 576i/p, 1280 x 720p, 1920 x 1080i/p) video input.

•If the recorder’s internal HDD is damaged or broken, there will be no HDMI output.

•Not all HDCP-compatible DVI devices will work with this recorder.

No video from the HDMI	• If you choose a setting that is incompatible with your TV you may not be able to see any picture at
output	all. In this case, press OPEN/CLOSE while holding down the (Stop) button on the front panel to
	switch the setting (this also switches Component Video Out on page 139 to the default setting).
There’s no sound from the	• There is no sound when using a DVI terminal.
connected HDMI or DVI	• Some HDMI-compatible devices do not output sound (check with the manual that came
device	with the connected device).

If the unit does not operate normally due to external effects such as static electricity, disconnect the power plug from the outlet and insert again to return to normal operating conditions.

If the picture freezes and the front panel and remote control buttons stop working

• Press (Stop) then try restarting playback.

STANDBY/ON
• Press the front panel STANDBY/ON button to
switch the power off, then switch back on and restart
playback. If the power fails to switch off, press and
hold STANDBY/ON for five seconds until the		HDD/DVD
power switches off.
A.TV D.TV PLTV DivX		COPY
STANDBY/ON DV IN	USB	COMMON INTERFACE

CH

OPEN/CLOSE

STOP REC

INPUT

SELECT

155

En