10Additional information
ProblemRemedy
Can’t operate using the remote control.
•Replace the batteries (Putting the batteries in the remote control on page 21).
•Operate within 7 m, 30° of the remote sensor (Using the remote control on page 20).
•Remove any obstacles or operate from another position.
•Avoid exposing the remote sensor on the front panel to direct light.
•For operating the HDD/DVD recorder, make sure that the control cable and coaxial cable are connected (page 10).
•If the receiver subwoofer is connected to a Pioneer plasma display with an SR+ cable, check that the plasma display is switched on. Point the remote control at the plasma display in order to operate the receiver subwoofer.
•Check that nothing is mistakenly plugged into the CONTROL IN jack.
Tuner
Problem | Remedy |
Considerable noise in radio | • Connect the AM antenna (refer to Connecting up on page 10) and adjust the direction |
broadcasts. | and position for best reception. You may also connect an additional internal or external AM |
| antenna (refer to Connecting external antennas on page 34). |
| • Fully extend the FM wire antenna, position for best reception, and secure to a wall. You |
| may also connect an outdoor FM antenna (see Connecting external antennas on page 34). |
| • Turn off other equipment that may be causing the noise or move it further away. |
Auto tuning does not pick up some stations.
•The radio signal is weak. Auto tuning will only detect radio stations with a good signal. For more sensitive tuning, connect an outdoor antenna.
Error Messages
Message | Description |
2CH ONLY | • An operation is prohibited because it is only applicable to 2 channel sources, while the |
| current source is a multichannel source. |
|
|
96K | • An operation is prohibited because the source is 96 kHz digital. |
|
|
EXIT | • Appears when a menu is automatically exited after a set period of inactivity. |
|
|
NOISY | • Background noise is too high to complete MCACC setup successfully. |
|
|
ERR MIC | • An error occurred during MCACC setup because the microphone is not connected or is |
| not connected properly. |
|
|
ERR SP | • An error occurred during MCACC setup because the speakers are not connected or are |
| not connected properly. |
|
|
EEP ERROR | • Contact your Pioneer authorized service center or your dealer for servicing. |
|
|
NO SPTYP | • Try switching the unit off then on again. If the error still appears, please contact a |
| Pioneer authorized service center or your dealer. |
|
|
38
En
